Therapy with basic settings
- (A) Connect the power cable to the QRS 101 control device
- (A) Connect the applicator cable to the QRS 101 control device
Connect the full-body applicator to the connector “Applicator A”. You can also connect the pillow to the connector “Applicator B”.
Note: It is not necessary to connect both applicators simultaneously.
- (1) Switch on the QRS device
- (2) Select one of the three programs
- (3) Set the therapy duration
- (4) Select the intensity
- Lie down on the mat, and if using the pillow, place it on the location to be treated.
- (5) Start the therapy
Therapy with individual settings
The basic settings can only be changed when the device is switched on. Settings cannot be modified during the therapy.
Setting the intensity from level 1 to 10
It may be a good idea to change the intensity if a targeted QRS therapy is to be applied.
Furthermore, it is recommended that a higher intensity be used if you have installed the QRS mat in bed, for example. If the QRS mat is located under the mattress you sleep on, the distance to the effect field increases. The intensity should be increased by one level for each 10 cm of mattress thickness.
- (1) With the QRS device switched on, press and hold the intensity button for 2 seconds.
- A blinking intensity setting now appears on the display.
- Depending on whether you wish to increase or reduce the intensity, press (as shown in the illustration) the left or right setting button.
- Confirm the setting by pressing the A/B ok button between the setting buttons.
- The last value configured will remain saved.
Modifying the therapy duration from 1 to 60 minutes
It is recommended that the therapy time only be changed if you have the feeling that it will be beneficial for you. For example, sleep disorders can, among other things, be improved by increasing the therapy duration to 60 minutes.
- (1) With the QRS device switched on, press and hold one of the time selection buttons for 2 seconds.
- A blinking time setting now appears on the display.
- Depending on whether you wish to increase or reduce the therapy time, press (as shown in the illustration) the left or right setting button.
- Confirm the setting by pressing the A/B ok button.
- The last value configured will remain saved.
Other functions
For detailed instructions on using the other functions, please refer to the QRS 101 Operating Manual.
(A) Switching between applicators
If you have connected the mat and the pillow simultaneously, you can switch between the applicators using the A/B key.
- To do so, press the A/B key
- Press the right button (right arrow symbol) to switch to the applicator connector B (pillow)
- Press the left button (left arrow symbol) to switch to the applicator connector A (mat)
- Press the A/B button again to confirm the connector selection
(B) Switch display light on or off
The illumination of the display can be turned off automatically by the device so that, for example, your sleep is not interrupted.
- Press the I/O button (left) with the light symbol to either activate or deactivate the automatic shutoff.
(C) Configure automatic start of QRS therapy
It may be a good idea to configure the automatic initiation of a therapy session if you have installed the QRS mat in bed. You can configure 2 therapy starting points, e.g. in the morning before you wake up and at night when you go to bed.
- For information on configuring the automatic start of therapy, please refer to the QRS 101 Operating Manual.
(B) Switch sound on or off
When the QRS therapy ends, a sound is played. This sound can be turned off so that, for example, your sleep is not interrupted.
- Press the I/O button (right) with the sound symbol to turn the sound emitted on or off when QRS therapy ends.
Request original QRS manual
The original QRS manual is provided with the QRS 101 Home System. If you do not have an original manual and require one, please contact us.
